OperationCold Bending Forming MachineSafety And Regulations Are Particularly Important. Before Starting Up, Be Sure To Check The Equipment, Tighten All Screws And Accessories, Check The Lubrication Of Gears And Bearings, Ensure That The Roller Surface Is Clean And Free Of Debris, And Avoid Scratching The Board And Damaging The Mold. At The Same Time, Check Whether The Circuit And Switch Are Intact, Confirm That The Raw Material Specifications Meet The Equipment Processing Range, And Prohibit Overloading Production.
Before Starting The Equipment, Conduct A No-load Trial Run To Confirm That There Is No Abnormal Noise Or Jamming, And Then Feed Smoothly. Keep The Feeding Straight And Uniform, And Do Not Forcefully Push Or Feed The Board At An Angle. During The Operation Of The Machine, It Is Strictly Prohibited For Hands Or Tools To Approach Dangerous Areas Such As Rollers, Cutting Edges, And Chains, And Protective Devices Must Not Be Removed At Will.
During Production, Observe The Forming Effect Of The Profile At All Times. If There Are Problems Such As Deviation, Deformation, Or Abnormal Noise, Stop The Machine Immediately For Troubleshooting. Eliminate Frequent Emergency Stops And Parameter Adjustments To Reduce Equipment Wear And Tear.Clean Up Iron Filings And Oil Stains In A Timely Manner After Daily Completion, And Ensure Proper Equipment Cleaning. Regularly Add Lubricating Oil, Maintain Vulnerable Parts, Cut Off Power If Not In Use For A Long Time, And Do A Good Job Of Rust Prevention For The Rollers. This Can Ensure Operational Safety And Extend The Service Life Of The Equipment.
